상품명 | PPM Encoder V1.0 S-BUS |
---|---|
영문명 | PPM Encoder V1.0 S-BUS |
PPM Encoder V1.0 S-BUS | |
원산지 | 중국 |
상품코드 | P0000GDJ |
판매가 | 19,900원 |
적립금 |
|
배송비 | 3,500원 (100,000원 이상 구매 시 무료) |
QR코드 | |
수량 | ![]() ![]() |
SNS 상품홍보 | ![]() ![]() |
---|
![]() |
(최소주문수량 1개 이상 / 최대주문수량 0개 이하)
사이즈 가이드할인가가 적용된 최종 결제예정금액은 주문 시 확인할 수 있습니다.
PPM Encoder V1.0 S-BUS
1. 제품명 : PPM Encoder V1.0 S-BUS
2. 간략설명 : 일반적인 PWM방식(신호1개당 신호선1개사용)의 2.4G 송수신기 방식을 PPM방식으로 변경해주어
신호선 1개로 모두 컨트롤이 가능하도록 후타바의 S-BUS 형태로 사용할수있는 PPM Encoder V1.0 S-BUS입니다..
3. SPEC..
- 크기 : 28 X 19 X 5mm
- 무게 : 9g
4. 구성품..
- PPM Encoder 1개
- 10Pin input cable 60mm 1개
- 4Pin output cable 100mm 1개
PPM Encoder V1.0 S-BUS 수신기에 연결예시입니다..
The PPM Encoder plugs into the PWM servo output ports of any R/C receiver and
encodes them into a PPM pulse suitable for many autopilots (e.g. Pixhawk).
Modifications to the R/C receiver are not necessary.
The whole project is based around the ATMEL ATMEGA328p AVR processor and
all timing is done within interrupts so accuracy and stability is optimized.
Firmware is free and was created by John Arne and Olivier Adler.
The design of the PPM Encoder is based on the Paperazzi PPM Encoder.
Important Note: The firmware comes pre-configured to read 8 Channels.
In case you would like to change the settings of the PPM encoder to invert the PPM signal and
change the fail safe pre-defined values you will need an AVR ISP programmer in order to reprogram it.
The jumper on the board no soldering default. In this case the board powered by FC
* 주의 : 교환, 반품은 제품 미개봉 상태이여야 가능합니다.
A/S 안내
교환 및 반품정보
환불정보